Real-time Identification of Electric Motor Faults Using Arduino
Keywords:
Overvoltage, Undervoltage, Overcurrent, Arduino , PZEM-004t, Fault identification, Induction motorAbstract
The reliability of electric motors is very important in various industries. Damage to electric motors caused by disturbances that are not detected early results in large losses, both in terms of time and cost. This research aims to design and build an Arduino-based electric motor fault detection device equipped with a PZEM-004t sensor, buzzer as an alarm, relay to turn off the motor when there is a disturbance and LCD I2C 16x2 to display the measured value. This tool is designed to provide protection to the motor from overvoltage, undervoltage and overcurrent disturbances. Based on the results of testing and analysis, the designed tool can detect and protect the motor from interference. The buzzer functions effectively as an alarm when the voltage and current values are close to the fault occurrence value. The relay can respond well in breaking the current in the motor when a disturbance occurs. Thus, this tool has the potential to be applied as a practical solution in preventing damage to electric motors in industrial environments
Downloads
References
[1] S. Kumar et al., "A Comprehensive Review of Condition Based Prognostic Maintenance (CBPM) for Induction Motor", IEEE Access, vol. 7, pp. 90690-90704, 2019
[2] A. F. Ikhsan, N. Irman, and A. Priatna Wandi, “Rancang Bangun Sistem Kontrol dan Monitoring Motor Induksi 3 fasa Dengan Menggunakan Mikrokontroler Arduino Uno di PDAM Garut,” J. Penelit. dan Pengemb. Tek. Elektro Telekomun. Indones., vol. 10, no. 1, pp. 17–24, 2019
[3] K.V.S.R. Prasad and V. Singh, "Numerical Investigation and Experimental Modal Analysis Validation to Mitigate Vibration of Induction Machine Caused due to Electrical and Mechanical Faults", J. Electr. Eng. Technol, vol. 17, pp. 2259-2273, 2022.
[4] P. R. Adam, Purwanto Gendroyono, and Nur Hanifah Yuninda, “Monitoring Suplai Tegangan Pada Motor Induksi Tiga Fasa Menggunakan Mikrokontroler Arduino Dan Sensor Tegangan Zmpt101B,” J. Electr. Vocat. Educ. Technol., vol. 5, no. 2, pp. 37–43, 2020
[5] K. Widarsono, M. Jauhari, and A. L. Dzuhuri, “Relay Protection of Over Voltage, Under Voltage and Unbalance Voltage Magnitude Based on Visual Basic Using Arduino Mega,” Semin. MASTER, pp. 39–48, 2019.
[6] Aceng Daud, “Rancang bangun modul proteksi arus beban lebih dan hubung singkat,” J. Tek. Energi, vol. 9, no. 1, pp. 37–44, 2019, doi: 10.35313/energi.v9i1.1643.
[7] M. Fahreza, “Desain Controling Pengaman Arus Lebih Berbasis Arduino,” J. MESIL (Mesin Elektro Sipil), vol. 2, no. 1, pp. 47–53, 2021.
[8] T. Muchtar, S. N. Djabir, and A. Dimas, “Power Monitoring System Design on 3 Phase Electric Motor,” JEAT J. Electr. Autom. Technol., vol. 1, no. 1, pp. 30–39, 2022.
[9] I. Rifaldo and M. Yuhendri, “Sistem Monitoring Kecepatan Motor Induksi dengan HMI Berbasis PLC,” JTEIN J. Tek. Elektro Indones., vol. 3, no. 2, pp. 319–325, 2022.
[10] O. E. Hassan, M. Amer, A. K. Abdelsalam and B. W. Williams, "Induction motor broken rotor bar fault detection techniques based on fault signature analysis-a review" IET Electric Power Applications, vol. 12, no. 7, pp. 895-907, 2018.
[11] R. D. J. Kartika Sari, Y. C. Arief, and S. Suryono, “Rancang Bangun Elektronik Motor Relay sebagai Proteksi Berbagai Gangguan Motor Listrik,” JASIEK (Jurnal Apl. Sains, Informasi, Elektron. dan Komputer), vol. 4, no. 2, pp. 67–78, 2022, doi: 10.26905/jasiek.v4i2.8921.
[12] D. Darmawansyah, M. K. A. Rosa, and I. N. Anggraini, “Sistem Proteksi Motor Induksi 3 Fasa Terhadap Bermacam Gangguan Menggunakan Mikrokontroller,” J. Amplif. J. Ilm. Bid. Tek. Elektro Dan Komput., vol. 10, no. 1, pp. 9–17, 2020.
[13] M. Markiewicz, M. Wielgosz, M. Bocheński, W. Tabaczyński, T. Konieczny and L. Kowalczyk, "Predictive Maintenance of Induction Motors Using Ultra-Low Power Wireless Sensors and Compressed Recurrent Neural Networks", IEEE Access, vol. 7, pp. 178891178902, 2019.
[14] J. F. D. Santos et al., "Digital Twin-Based Monitoring System of Induction Motors Using IoT Sensors and Thermo-Magnetic Finite Element Analysis", IEEE Access, vol. 11, pp. 1682-1693, 2023.
[15] F. Hanifah and M. Yuhendri, “Kontrol dan Monitoring Kecepatan Motor Induksi Berbasis Internet of Things,” JTEIN J. Tek. Elektro Indones., vol. 4, no. 2, pp. 519–528, 2023
